Face Angle Half-Back

What is Face Angle @ Half-Back?

This parameter measures the face angle at the half-back position. Half-back refers to the position in the backswing when the shaft becomes parallel with the ground for the first time. Face angle at half-back is measured relative to the vertical, and is 0° when the toe points straight up. The farther downward the toe points, the more closed the club face.

What should Face Angle @ Half-Back be?

Different golfers prefer different face angles at half-back. A good rule of thumb is that the leading edge of your club face should lie parallel to your spine. This typically reads around 30° to 40° closed at half-back. When you find the angle for each club that results in solid hits, groove that value.

Shaft Lean Address

What is Shaft Lean @ Address?

Shaft lean is a measure of how far the hands are pressed forward or backward at address. A forward shaft lean, or "forward press", indicates that the hands were ahead of the ball. A backward shaft lean indicates the hands were behind the ball. Shaft lean is defined as the angle from the club shaft to the vertical.

What should Shaft Lean @ Address be?

The proper shaft lean at address varies with club, player, and shot type. It is common for short irons and wedges to have a small forward shaft lean. Mid irons tend to be around 0°, while long irons and woods often have a small backward shaft lean. When you find a Shaft Lean @ Address that works for you, groove that value.

Shaft Angle Address

What is Shaft Angle @ Address?

Shaft angle is a measure of how steep or flat the club shaft is held at address. Higher numbers indicate higher hands and/or shorter clubs. The shaft angle is defined as the angle from the ground to the club shaft.

What should Shaft Angle @ Address be?

To find your shaft angle for a particular club, point the club at your belt and swing the club. You can then mark this swing as a favorite for easy reference later. Longer clubs will have lower shaft angles, and vice versa. To a large extent, your shaft angle determines the plane of your swing. You stand closer to the ball with the short wedge, resulting in a higher shaft angle and a steeper swing plane. The opposite is true with the driver.

Tips on Shaft Angle @ Address

Work to maintain that number in Groove Practice and also strive to repeat that number at impact as explained in “Shaft Angle @ Impact”.

Swing Tempo

What is Swing Tempo?

This is a measure of your backswing and downswing times presented as a ratio. In other words, if your backswing was three times longer than your downswing, your tempo would be 3:1. Note that the overall length of your swing doesn’t matter, only the relative times between your backswing and downswing. For example a 3 second backswing with a 1 second downswing would have the same tempo ratio as a 6 second backswing with a 2 second downswing.

Do not confuse swing tempo with swing speed. Your swing speed is how fast the club is moving at a particular point in the swing, not the ratio of the backswing to downswing times.

What should Swing Tempo be?

A good Swing Tempo is usually around 3:1 for a full swing. This was originally determined by John Novosel, who discovered that most tour professionals have a remarkably consistent tempo. For example, he analyzed videos of Jack Nicklaus and Ben Hogan and found they both had 21 frames in the backswing and 7 frames in the downswing. Fred Couples and Tiger Woods had 24 and 8, and Bobby Jones had 27 and 9. All three measurements have a different number of frames total, but the ratio between them is always the same - 3:1.

What should your particular tempo be? Like most aspects of the golf swing, tempo will vary slightly between players. However, since most professionals’ tempos are close to 3:1 for a full swing, that suggests yours should be too. Be aware these 3:1 tempo measurements were taken using video at 30 frames per second, and therefore have much lower resolution than SkyTag. This means that it’s very unlikely that all these professionals would read exactly 3.0 : 1 on the SkyTag, although they would be pretty close. Short game tempos are often a little quicker, usually around 2:1.

Once you've settled on your best swing tempo, try grooving that value in Groove Mode.

Face Angle Top

What is Face Angle @ Top?

This parameter measures your face angle at the top of the backswing. It is measured in degrees below horizontal, instead of open or closed, because a neutral face angle at top (one that is neither open nor closed) depends on the body and will change from golfer-to-golfer and swing-to-swing. In other words, 0° is not a good Face Angle @ Top to have - in fact, it would be a very closed club face.

What Should Face Angle @ Top Be?

Your best Face Angle @ Top depends on your own particular swing mechanics. A face is usually considered to be neutral (neither open nor closed) when the wrists are not bowed or cupped. This means the club face should be parallel to the back of the lead forearm. As a rough rule of thumb, 0° is a closed club face, 90° below horizontal is an open club face, and a neutral face is between 45° and 60° below horizontal for most golfers. We suggest you determine your own correct Face Angle @ Top by asking an instructor, using video, or analyzing your favorite SkyTag swings - then groove that value.

Clubhead Speed

What is Clubhead Speed?

It is a measure of the speed of your clubface at impact. Clubhead Speed is important because it is one of the most important factors in determining how far your ball will travel.

There are multiple definitions of clubhead speed. SkyTag will always report the speed at the center of your club face, no matter where it makes contact with the ball. This allows you to compare the speed of two swings, even if you hit one on the heel and the other on the toe. However, you should be aware that other clubhead speed measurement systems may do the opposite and measure clubhead speed at the point of contact with the ball. Because the club is rotating so quickly, this may differ by as much as 4 MPH.

SkyTag also reports clubhead speed throughout your entire backswing and downswing in graphical form. This velocity profile can help you determine if you jerked your club back during takeaway, if you smoothly transitioned from backswing to downswing, and if you held your lag during the downswing. Good swings typically show a smooth takeaway and transition, with the majority of the acceleration occurring during the last half of the downswing. Try comparing high speed swings with lower speed swings to find dissimilarities between their acceleration profiles.

Rise Angle Impact

What is Rise Angle @ Impact?

Rise angle is a measure of the vertical direction of the putter's velocity at impact. Positive values indicate the putter head is travelling upwards away from the green, while a negative value indicates the putter is traveling downwards into the green.

What should Rise Angle @ Impact be?

Rise angle plays a critical part in achieving good ball roll, which is characterized by a smooth start free of any hops, skips, and backspin. While the optimum rise angle depends on a number of factors, including the loft of the putter at impact and the speed of the green, a good rule of thumb is that the rise angle should be slightly greater than the loft at impact.

As previously mentioned, the optimum rise angle depends on the loft of the putter at impact and the speed of the green. Some instructors teach that a positive loft at impact helps to launch the ball out of its slight divot on the green. However, positive loft at impact will result in backspin on the ball. Backspin is undesirable because it results in the ball slipping and sliding rather than rolling smoothly end over end. With a rise angle greater than loft, the ball is both launched out of its divot and given topspin to ensure it rolls smoothly.

In summary, you should aim for a rise angle slightly greater than loft. This tr